Peptide Isoelectric Point (pI): How to Calculate Net Charge at Any pH

For in vitro laboratory research use only. This article explains analytical chemistry terms. It makes no claims about the effects of any material.

A peptide’s isoelectric point, or pI, is the pH at which the peptide carries no net electric charge. Above that pH it carries a net negative charge, and below it a net positive charge. The pI comes straight from the sequence, so it can be estimated on paper. This guide explains which groups carry charge, how to calculate net charge at a given pH, how to find the pI, why different calculators give different answers, and where pI matters in the lab.

Which groups carry charge

Most of a peptide chain has no charge of its own. Charge sits on a small set of ionizable groups, each with a typical pKa, the pH at which that group is half charged:

  • The free N-terminal amine. Positive when protonated, below its pKa.
  • The free C-terminal carboxyl. Negative when it has lost its proton, above its pKa.
  • Acidic side chains: aspartic acid (D) and glutamic acid (E), negative above their pKa. Cysteine (C) and tyrosine (Y) can also lose a proton, but only at fairly high pH.
  • Basic side chains: lysine (K), arginine (R) and histidine (H), positive below their pKa.

So the first step is to count these groups in the sequence. Our guide to peptide sequence notation explains how to read one-letter and three-letter codes.

How net charge changes with pH

Each ionizable group is either mostly charged or mostly uncharged depending on how far the pH is from its pKa. The Henderson-Hasselbalch equation gives the fraction that is charged:

  • For a basic group: charge = +1 / (1 + 10^(pH − pKa))
  • For an acidic group: charge = −1 / (1 + 10^(pKa − pH))

One pH unit away from the pKa, a group is about 91% in one form. Two units away, about 99%. The net charge of the peptide is the sum over all its ionizable groups. At very low pH, every basic group is positive and almost every acidic group is neutral, so the net charge is positive. At very high pH, the reverse is true and the net charge is negative. Somewhere in between, it passes through zero. That pH is the pI.

A worked example

Here is an example with made-up numbers, not a real product. Take the five-residue peptide Gly-Asp-Lys-Ala-Phe (GDKAF), with a free N-terminus and a free C-terminus. It has four ionizable groups. The pKa values below are the EMBOSS set, one of several published sets:

Group Type pKa (EMBOSS set) Charge at pH 2 Charge at pH 7 Charge at pH 12
N-terminal amine Basic 8.6 about +1 about +0.98 about 0
Lys side chain Basic 10.8 about +1 about +1 about +0.06
Asp side chain Acidic 3.9 about −0.01 about −1 −1
C-terminal carboxyl Acidic 3.6 about −0.02 about −1 −1
Net charge about +1.96 about −0.02 about −1.94

At pH 7, the two positive and two negative charges almost cancel. Solving for the exact pH where the net charge is zero gives a pI of about 6.34 for this set of values.

The quick estimate

For a short peptide, there’s a shortcut. List the pKa values in order and step through them from low pH to high pH, removing one positive charge (or adding one negative charge) at each step. Find the two pKa values on either side of the point where the net charge is zero, then average them.

For GDKAF, the order is 3.6 (C-terminus), 3.9 (Asp), 8.6 (N-terminus), 10.8 (Lys). The net charge is +2 at low pH, +1 after the C-terminus, 0 after Asp, −1 after the N-terminus and −2 after Lys. The zero-charge form sits between 3.9 and 8.6, so the estimate is (3.9 + 8.6) / 2 = 6.25. That is close to the full calculation (6.34). The two differ a little because groups with nearby pKa values overlap, so the shortcut is an estimate.

Why pI calculators give different answers

Ask two pI calculators about the same sequence and the answers often differ. The math is the same; the pKa values are not. Several published pKa sets are in common use, measured or fitted under different conditions. A short comparison, using the same made-up example peptides:

Example peptide Ionizable groups pI (EMBOSS set) pI (Lehninger textbook set)
Gly-Asp-Glu-Ala-Phe (GDEAF) 3 acidic, 1 basic about 3.55 about 3.01
Gly-Asp-Lys-Ala-Phe (GDKAF) 2 acidic, 2 basic about 6.34 about 6.75
Gly-Lys-Arg-Ala-Phe (GKRAF) 1 acidic, 3 basic about 11.65 about 11.49

Peptides rich in Asp and Glu have a low pI, and peptides rich in Lys and Arg have a high pI. Differences of a few tenths of a pH unit between sets are normal. A real peptide can also differ from any calculation, because neighboring groups shift each other’s pKa values. A calculated pI is best read as an estimate. When a measured value is needed, labs use methods such as capillary isoelectric focusing.

How end groups and modifications change the pI

The calculation assumes a free N-terminus and a free C-terminus. Common modifications change the count of ionizable groups:

  • C-terminal amide. The C-terminus is capped as an amide, so it carries no negative charge. This raises the pI.
  • N-terminal acetylation. The N-terminal amine is capped, so it carries no positive charge. This lowers the pI.
  • Disulfide bonds. Cysteines joined in a disulfide bond no longer have an ionizable thiol, so they drop out of the calculation.
  • Pyroglutamate. An N-terminal glutamine or glutamic acid that has cyclized to pyroglutamate has no free N-terminal amine.

Sequence notation often shows these as “-NH2” at the C-terminus or “Ac-” at the N-terminus, so check both ends before calculating.

Where pI matters in the lab

Net charge decides how a peptide behaves in several analytical methods:

  • Electrophoresis and isoelectric focusing. In an electric field, a peptide with net positive charge moves toward the negative electrode and one with net negative charge moves toward the positive electrode. In isoelectric focusing, a pH gradient is set up, and each peptide moves until it reaches the pH equal to its pI, where it stops. That is how pI is measured.
  • Ion-exchange chromatography. Below its pI, a peptide is net positive and is retained on a cation exchanger. Above its pI, it is net negative and is retained on an anion exchanger. The same principle is used for salt exchange, covered in our guide to TFA vs acetate peptide salts.
  • Reversed-phase HPLC. Peptide purity methods often use a mobile phase with about 0.1% trifluoroacetic acid, at a pH of roughly 2. At that pH, most peptides are net positive, and the trifluoroacetate ions pair with the positive groups, which helps give sharp peaks. Our guide to reading an HPLC chromatogram explains what those peaks show.
  • Mass spectrometry. In positive-mode electrospray, protons attach mainly at basic sites, so a peptide with more basic residues tends to show higher charge states. Our explainer on peptide molecular weight and mass spec covers how charge states appear as m/z values.

pI and the certificate of analysis

A certificate of analysis doesn’t usually report a pI, because it’s a calculated property of a sequence rather than a lot result. A certificate reports results for the sample tested. It is not a guarantee for other lots.

Frequently asked questions

What is the isoelectric point of a peptide?

It is the pH at which the peptide’s positive and negative charges balance, so its net charge is zero.

How do you calculate the isoelectric point of a peptide?

Count the ionizable groups (both ends plus D, E, C, Y, K, R and H side chains), assign each a pKa, and find the pH where the summed charges equal zero. For a short peptide, averaging the two pKa values on either side of the neutral form gives a quick estimate.

What is a peptide’s net charge at pH 7?

It depends on the sequence. Add about +1 for each Lys and Arg, about −1 for each Asp and Glu, and about +1 and −1 for a free N-terminus and a free C-terminus. Histidine is only partly charged at pH 7.

Why do pI calculators disagree?

They use different published pKa values. Differences of a few tenths of a pH unit are common.

Does a C-terminal amide change the pI?

Yes. An amide removes the negative charge of the C-terminal carboxyl, so the pI goes up.

Is pI listed on a peptide certificate?

Not usually. It’s calculated from the sequence rather than measured for each lot. Check which tests a certificate lists. For other terms, see our research peptide glossary.

Peptix certificates

The peptide lots with a published certificate on our peptide COA lookup page each have a third-party Certificate of Analysis showing the lot number, HPLC-UV purity and LC-MS identity. Where a certificate reports net content, the measured amount is printed on that certificate. For example, you can view the TB-500 10 mg, BPC-157 10 mg or BPC-157 / TB-500 20 mg product with its lot certificate, or browse all research peptides.

For research use only. Not for human or animal use.

logo
Research customers only

Peptix sells research materials only to qualified researchers and research institutions, for in vitro laboratory research. Not for human or animal use. By continuing, you confirm you are a researcher or are buying for a research organization, and that you are of legal age to enter a binding contract.